Swiftech H20 120 R3 User Manual download pdf (Page 39)

Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail:

[email protected] – URL: http://www.swiftnets.com

Square cut

Figure 20

Figure 21

Figure 22

Figure 23

Figure 24

c. Spread a little bit of grease or liquid

soap

around the tubing. It helps pushing the

tubes in, particularly with Clearflex

 tubing,

which features a very “sticky” surface.

d. Fully insert both tubes into the fittings. The tip of the plastic tube inserts should

be flush with the inlet and outlet openings, as shown in figure 4 above. Inserting the

tubes requires a firm push, accompanied by a twisting motion.

2. Installation for Intel platforms

a. Prepare your Motherboard



Remove the existing heat sink

 Carefully clean the processor, using alcohol

 Install the 4 neoprene pads as shown figure 8. This

step is only necessary if the processor core is

exposed.

If the chipset features a heat spreader (a

large lid covering the entire area of the chipset),

then the neoprene pads MUST not be installed.

 Lightly coat the CPU with the included Arctic

Céramique thermal compound. Application will vary

depending on the type of processor. We recommend

visiting http://www.arcticsilver.com for detailed

instructions.

Figure 25

- Information subject to change without notice Page 39 of 41

1 2 ... 34 35 36 37 38 39 40 41

No comments

Swiftech H20 120 R3 User Manual Page 39