Swiftech MCP655 User Manual download pdf

Rouchon Industries, Inc., dbA Swiftech – 1703 E. 28

Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769

E Mail: Swiftech @swiftnets.com – URL: http://www.swiftnets.com

- Information subject to change without notice

Page 1

 General Use

The MCP655 pump is a magnetically driven centrifugal

pump featuring a 12 V DC motor. It requires no

maintenance when used with de-mineralized water and

the appropriate anti-fungal additives. We recommend

using 5% Swiftech’s HydrX™ as an additive. The pump is

designed to be connected to your computer power supply

using the standard Molex 4 pin connectors.

The MCP655 pump is neither submersible, nor self-

priming. The inlet needs to be continuously supplied with

fluid for the pump to operate properly.

 Physical installation

 Determine the best location for your pump by

observing how the tubing will be routed to the rest of

the circuit. Sharp bends in the tubing should always

be avoided to prevent kinks, which will reduce or

completely prevent flow of the cooling fluid.

 In general, we recommend installation of the pump

at the bottom of the chassis.

 The base of the pump features a soft neoprene pad

coated with strong adhesive material. Once the final

location for the pump has been determined, simply

peel-off the pad’s protective paper, and press the

pump against the chassis surface. The surface

should be clean, and non greasy. Thru-bolts are also

provided for permanent installation, and require

drilling holes in the chassis.

 The back of the pump features a potentiometer to

allow users to vary the pump speed from 1800 to

4800 rpm. Full speed is suggested for maximum

performance. When reducing the pump speed, the

operating noise will also decrease proportionally, but

so will the performance. A flow rate chart is provided

below

 Pump operating precautions:

The MCP655 pump should never be run dry, even for

a quick test. You should always prime the pump with

fluid before you start operating it (see warranty note *).

Use of coloring die or fluorescent additives containing

particulate fillers will cause excessive wear to the pump’s

impeller bearing (see warranty note **).

Note: It is preferable to directly connect the RESERVOIR DISCHARGE to the

PUMP INLET (no other components between pump and reservoir)

Specifications

Nominal voltage / Connector 12 V DC / Molex 4 pin Maximum pressure 50 PSI (3.5 BAR)

Operating voltage range 8 to 24 VDC Maximum head 10 ft (3.1 m)

Nominal current (@ 12 V) 2 amps Maximum discharge ~ 317 GPH (1200 LPH)

Nominal power (@ 12 V) 24 W Temperature range 32 °F to 140°F (0 °C to 60 °C)

Motor type Brushless, microprocessor controlled Weight 1.4 LB (650 gr.)

Impeller Housing material Noryl® Connection size ½" barbs

1 2

Summary of Contents

Page 1

Page 2

Swiftech MCP655 User Manual

Browse online or download User Manual for Computer Accessories Swiftech MCP655. Swiftech MCP655 User Manual

Summary of Contents

More documents for Computer Accessories Swiftech MCP655

Comments to this Manuals

Swiftech MCP655 User Manual

Browse online or download User Manual for Computer Accessories Swiftech MCP655. Swiftech MCP655 User Manual

Summary of Contents

More documents for Computer Accessories Swiftech MCP655

Comments to this Manuals

Related products and manuals for Computer Accessories Swiftech MCP655