Swiftech H20 220 APEX ULTIMA PLUS User Manual Page 1

These instructions are updated on a regular basis. Please visit our web site at www.swiftech.comCopyright Swiftech 2008 – All rights reserved – La

Figure 8 Figure 9 Figure 7 Fasten the hold-down plate assembly to the Apogee™ GTZ water-block Peel-off the protective paper from all four foam st

Please refer to the separate installation guide inlcuded with the MCW60 water-block. 5. RE-INSTALLING THE MOTHERBOARD Once your water-blocks are secu

Permanent installation to the chassis, and exploded view Nominal voltage / Connector 12 V DC / Molex 4 pin Maximum pressure 50 PSI (3.5 BAR) Op

Figure 1 Port Usage definition Upper side port: “Inlet” as shown in figure 1 is the return line from the system Lower side port: “Outlet (to pump)” s

ITEM NO. PART NUMBER DESCRIPTION QTY.1 BCKT1 "L" bracket 12 BCKT2 "U" bracket 2390272A146-6-32x3-8-philips34 91772A158-6-32X1.756-

8. INSTALLING THE TUBING Gather the Smartcoils towards the center of the tubing, and then pull on the ends of the tubing. This will allow the coils

• Prior to fill-up the circuit, you will need to re-install your power-supply in order to start-up the pump during the fill procedure. You must be ab

Copyright Swiftech 2008 – All rights reserved – Last revision date: 10-29-08- Information subject to change without notice – URL: http://www.swiftech.

Packing List QTY ITEM 1 APOGEE GTZ water-block, including socket 775 and socket 1366 hold-down plates for Intel Core® (Core 2, Duo, Quad, Extreme,

TTAABBLLEE OOFF CCOONNTTEENNTTSS ...

INTRODUCTION Congratulations on your purchase of a Swiftech™ H20-APEX liquid cooling system! This kit has been designed to facilitate the installati

 From a performance standpoint there is very little performance to be gained from strictly controlling the component sequence: the maximum delta T (

1. MCR220 RADIATOR INSTALLATION Preamble: The MCR220™ dual 120mm radiator ships with the fans and the Radbox chassis already pre-assembled to the rad

 Installation  Place the radiator assembly on the back of the computer to roughly estimate where it will fit best.  You need to consider the fo

 Finally, you need to route the fan wires through the back-panel. This can be done easily with the provided PCI adapter plate featuring a hole and

3. Fasten the block to the motherboard 4. Install the tubing For optimal performance, it is critical to orient the water-block properly relative to